and should therefore be selected from the dialog box (the first time only). For all systems, the correct USB driver for the default USB-KBD interface is included in the Host Operating System and will either be loaded automatically or will be suggested by the O.S. Two basic conditions must be met before Heron is ready to read codes, the correct USB driver must be loaded and sufficient power must be supplied to the reader. During this phase the green LED on the Heron reader blinks and normal operations are suspended. Correct insertion will be signaled by a beep then, the reader will be ready to read barcodes.ħ INTERFACE SELECTION Follow the procedure to configure the interface required by your application - USB Interface - RS232 Interface - Wedge Interface - Pen Interface USB INTERFACE CONFIGURATION The USB interface is compatible with: Windows 98 (and later) Mac OS 8.0 (and later) IBM POS for Windows 4690 Operating System START-UP As with all USB devices, upon connection, the Host performs several checks by communicating with the Heron. INSERTION INTO STAND Pair the reader to the stand paying attention to insert the handle into the stand clip (see figure above). It is also possible to fix an optional metal plate. Then, remove the plastic from the other side of the strips and affix the stand to the table C) carefully clean the bottom surface of the stand, remove the protective film from the rubber feet and stick them in the corresponding housing on the bottom surface. Remove the protective plastic from one side of the adhesive strips and stick them on the stand bottom.
6 STAND INSTALLATION A B C The stand can be mounted by using self-tapping screws, double sided adhesive strips or rubber feet: A) mount the stand directly to the surface using the self-tapping screws B) carefully clean the bottom surface of the stand and the table surface.
0 kommentar(er)
